lkparab.blogg.se

If you see the white light, that tells you the remote is emitting IR.Below is a list of original owner's manuals for Yamaha remote codes.

You will need to view this through the camera's viewer as you will not be able to see IR (white light) with the naked eye. Simply point the top window of the remote (where the IR emits from) to the camera and press the button in question (or any button) on the remote to see if there's a white light emitting from the window. (infrared) To do this, you will need a digital camera or a cell phone camera to view the infrared light.

A non-Marantz device plugged into the Remote Control (RC-5) Input will disable the receiver / pre-amp's IR sensor and IR Flasher In.ģ) Please make sure that the remote is emitting IR. The first push will activate the remote and the second will activate the mode.Ģ) Please make sure there's no source device or output device plugged into the Remote Control (RC-5) Input on the rear panel of your receiver or pre-amp. In some cases (on certain remotes) you may have to push the "AMP" button twice. To do this, simply press the "AMP" button on the remote. This will activate the remote to communicate fully with your receiver or pre-amp. The following are some troubleshooting steps to test that the remote and the unit's IR sensor are physically operating properly:ġ) Please make sure the remote is in "AMP" mode. The remote control unit operating mode is used to operate other devices. (Select "M" for normal Main Zone operation) Press ZONE SELECT to select the zone to operate. The operation target zone does not correspond to the zone setting specified on the remote control unit. etc), move it to a place in which the remote sensor won't be exposed to strong light. If the unit's remote control sensor is exposed to strong light (Direct sunlight, fluorescent light. Make sure there is a clear path between the remote and the unit and operate the remote control unit within a distance of about 23 ft/7 m from the unit and at an angle of within 30°. Confirm that the batteries are not worn out and are inserted in the proper direction.